HD Pro Duplicator - Advanced Setup - Power On Wait

Power On Wait is the amount of time the system waits between powering on the connected drives and executing a function. Setting this too low may cause some drives to be not recognized by the duplicator before a function begins. Tap the ENT button to change this option.

The Power On Wait can be set as 30, 60, 90, 120, 150, 180. The Power Off Wait is set to 30 by default.

To alter the Power On Wait setting:

1. Power on the duplicator.
2. From the Main Copy Menu press the ESC button to enter the Menu Select mode.
3. Press the Up or Down buttons until you see Advanced Setup.
4. When Advanced Setup is displaying for you, press the ENT button to enter this menu.
5. Press the Up or Down buttons until you see Power On Wait.
6. When Power On Wait is displaying for you, press the ENT button to alter the setting.
7. Use the Up or Down buttons to alter the setting.
8. Press the ENT button to save the setting.
9. Press the ESC button to return to the Menu Select mode.