11-Target NVMe Duplicator - General Operation - Full, Brief, and Resize Copy and Compare
The KanguruClone can copy data from a Source drive to Target drives in one of five modes:
|
Full |
FULL mode copies/compares drives sector by sector from the Source to the Target(s), and supports all OS formats (DOS/Windows/Mac/Linux) and file systems. This mode is the slowest copy mode but the most compatible with the highest rate of success. |
|
Brief |
Brief mode copies/compares only the sectors that contain data, skipping any blank sectors (including information hidden in sub channels). This is the typically the fastest copy mode, but only supports specific file systems. Brief mode supports the following file systems: FAT12/16/32/64, exFAT, NTFS, HFS, HPFS, EXT1/2/3/4, XFS, GPT, LVM, UFS, HPA, RIEF. |
|
Resize |
Resize copy is used to copy between Source and Target drives of different capacities. When duplicating in Resize mode, Target drives should all be the same capacity. Resize copy supports the following file systems: FAT, FAT32, NTFS. If the Source is not formatted as a supported file system, then the duplicator will automatically switch to Disk mode. Note: Comparing drives after a Resize copy will usually fail. |
After a copy has been performed, you can manually run a Compare operation to check the data on the Source drive against the data on the Target drives, to ensure that the all data was copied successfully. Note: Comparing drives that have been copied using RESIZE mode will often fail.
